SPLICING INSTRUCTION FOR JACKETED CABLES:
- Strip cable jacket to expose 1 foot of conductors. Lay the two ends of conductors over each other and stagger (cut sothe splices are not in the same location). Strip off each conductors primary insulation to insert in 1/2 the lengthof the butt connector.
- Cut the small heat shrink into lengths that are at least 2 inches longer than the butt connector and slide over each of the conductors. Slide these over the longest length of eachconductor to keep them away from butt connectors during solder operationupcoming.
- Drill a 1/8” hole in the center of each butt connector for soldering operation upcoming.
- Position butt connectors on one cable conductors and crimp in place. Then position the other set of conductors in butt connectors and crimp in place. Using solder iron or torch carefully heat up each butt connector and solder using typical electrical grade solder. Allow to cool or use a sponge and water to cool quicker.
