Products AccessoriesAluminum Direct Burial Splice Kit

Aluminum Direct Burial Splice Kit

P7395D-AG
Legacy:
Product Type

Splice Kits

Description
Complete kit to make cable to cable splice. Kit includes connectors, heat shrink, and electrical tape for all Quad AL configurations. Specially designed kit to splice Paige Agwire Quad Aluminum direct burial cable, all gauge sizes and configurations available.
Instructions
SPLICING INSTRUCTION FOR JACKETED CABLES:
  • Strip cable jacket to expose 1 foot of conductors. Lay the two ends of conductors over each other and stagger (cut sothe splices are not in the same location). Strip off each conductors primary insulation to insert in 1/2 the lengthof the butt connector.
  • Cut the small heat shrink into lengths that are at least 2 inches longer than the butt connector and slide over each of the conductors. Slide these over the longest length of eachconductor to keep them away from butt connectors during solder operationupcoming.
  • Drill a 1/8” hole in the center of each butt connector for soldering operation upcoming.
  • Position butt connectors on one cable conductors and crimp in place. Then position the other set of conductors in butt connectors and crimp in place. Using solder iron or torch carefully heat up each butt connector and solder using typical electrical grade solder. Allow to cool or use a sponge and water to cool quicker.
Kit Contents
  • 4) Aluminum butt connectors,
  • (4) 0.8”x48” heat shrink tubing
  • (4) 3”x48” heat shrink tubing.
FAQ
No FAQs available at this time.